Roll Your Own Hotswap SATA Guide
Guide and photos by Rick Stephens

 Last step, install the drives in your trays. Unlock the tray, flip the lever open and pull ’em out. Pop the cover off the tray and slip your drive in aiming the data and power connectors on the drive at the mating connections in the tray. Slide the drive back all the way to the rear to make full contact. Hold the drive in place and flip the tray over.

---

  Using the four coarse screws included with the hotswap trays (size 6-32) attach the drive to the tray from the bottom.

---

 Slip the cover back on and slide your completed trays into the Burly enclosure for a completed job.

---

 Marvel at your creation. Ready to rock and roll, absolutely perfect!

Return to MacGurus Hotswap SATA Kits page.

The Gurus Certify These Instructions Work